How do you adjust a craftsman carburetor?
How to Adjust a Carburetor in a Craftsman
- Locate the carburetor on your Craftsman equipment.
- Turn the main mixture and idle mixture screws on the carburetor counterclockwise about one full turn with a flat-head screwdriver.
- Start the engine with the transmission in neutral and let it run for several minutes.
How do you adjust the high and low on a Stihl chainsaw?
They are the high-speed, low-speed and idle adjustments respectively. Determine the carburetor type before adjusting the high- and low-speed screws. To do this, turn the “L” screw clockwise as far as it will go, using a flat-head screwdriver, then turn it counterclockwise as far as it will go.
How to start a Stihl MS 260 chainsaw?
MS 260 With the first recommended method, the chainsaw is started on the ground. Make sure the chain brake is engaged (see “Chain Brake” chapter in your instruction manual) and place the chainsaw on firm ground or other solid surface in an open area. Maintain good balance and secure footing.
What to look for when your ms260 won’t start?
Fuel line on 026 is tightly bent and twisted (as i know well from a 024 issue !! ) on rout to carb and in tank…check out as the air filter will push on it when you install it to. Impulse line …is it connected and not holed …. is the hole to the metering side of the carb plugged with crap.
Do you need to adjust the carburetor on a chainsaw?
Carburetor Adjustment for Chainsaws. Carburetor adjustment is critical on chain saws and other two-cycle engines. An adjustment that is too rich will cause a saw to smoke, have insufficient power, result in additional carbon build up and may damage the engine.
Are there pictograms in the MS 260 manual?
2 English / USA MS 260 Pictograms All the pictograms attached to the machine are shown and explained in this manual. The operating and handling instructions are supported by illustrations. Symbols in text