How do you connect Bluetooth to hoverboard?
Simply turn on your Bluetooth on your smartphone either in the settings or on iPhone can be found in the bottom navigation menu, wait a few moments for it to activate and the hoverboard product and simply just click pair once found, and your phone and the board will do the rest.
How do I reset my hoverboard?
Without moving your hoverboard, press and hold the power button for 10 seconds. Ignore all flashing lights and beeps in this 10 seconds. Then let go of the power button and turn the hoverboard off. The hoverboard is now reset and ready to be turned on.
How do you calibrate a hoverboard Bluetooth?
Here are the steps:
- Make sure the hoverboard is turned off completely.
- Make sure the hoverboard is on a flat, level surface.
- Now, push the power button on the board for five seconds, until it beeps.
- The lights on the board will flash.
- Wait 30 seconds.
Why is my hoverboard not working?
There are a few issues that might cause this to happen, including: The cables have come loose, or there is a bad connection. The internal circuits have malfunctioned. The balance sensors need to be recalibrated.
Why does a hoverboard have Bluetooth and how does it work?
Most HOVERBOARD ® products of ours do come with Bluetooth functionality. HOVERBOARD ® products with Bluetooth have the ability to play music and sounds from your smartphone device. The Bluetooth receiver is connected to speakers which are built within the HOVERBOARD ® product.
How can I connect my hoverboard to my Android phone?
Before you connect the Bluetooth on your Android phone to your hoverboard, go into your settings and enable Bluetooth. Now, go to your hoverboard and turn it on. Doing this will make your hoverboard “discoverable,” and allow your Android phone to pick up the Bluetooth signal.
What to do if your hoverboard is low on charge?
Check the hoverboard for low charge. This is indicated by a red light located between the foot pads. Fully charge the hoverboard. Then attempt to reconnect. If the hoverboard and device are out of range, Bluetooth pairing will fail. Successful pairing will occur when the hoverboard and the device are less than three feet apart.
Why is my hover 1 Charger not working?
If the hoverboard still fails to connect, there may be too many devices connected to it. The Hover-1 Charger can connect to one device at a time. If connection remains unsuccessful, disconnect all devices from the hoverboard and reconnect. If connection is still unsuccessful, the Bluetooth receiver must be replaced.