Why is my hot tub display not working?
If the control panel is frozen or dead, you have to check if the problem is the control panel or the circuit board. Examine if there is moisture in the display. Check if there are cracked buttons or if a part is wet. If the problem persists, turn the breaker off and disconnect the panel to examine the circuit board.
How do you clear a hot tub error code?
Solution A: Increase the hot tub water level If the water level is not correct, top up your tub with more water. Switch off the power and remove the filters. After 20 minutes, switch the power back on and run the spa/jets without the filters to see if it clears the flow issue.
How do I know if my hot tub circuit board is bad?
If you DO have 220 volts across both hot wires coming from the house, then next measure the voltage across both heating element pins. You should see 220 volts. If you do not, then the circuit board is faulty and will need to be replaced or sent to us for repair.
Where is the reset button on my jetted tub?
You will find a reset button typically on the heater unit. Usually there is a pilot light. When you’re ready to reset, push the button. Some spa units have a high limit switch which will turn off the spa heater if the thermometer fails.
Do hot tubs have a reset button?
A spa heater has a high-limit reset button. A spa or hot tub provides a form of personal relaxation known as hydrotherapy. A spa heater may need to be reset if it has tripped or stopped working. Using the high-limit reset switch and checking all breakers and GFCI outlets can reactivate the spa’s heater.
How do you clear the CF code on a Jacuzzi?
You must press the Jets Pump 1 button to confirm your selection or the current settings will remain active. When the countdown timer reaches â0,â the LED display will flash between âCFâ and the water temperature. At this time the filters must be replaced or cleaned and the timer reset.
Why does my hot water heater keep tripping the reset button?
The high resistance caused by a loose wire produces a substantial amount of heat that can eventually cause fires. If there is a loose electrical connection within your water heater’s system, your reset button’s thermometer can trip (regardless of the water’s temperature) if it picks up the heat from that loose wire.
Can jacuzzi turn on without water?
This means no water flow no heat. The only damage you could have had would be if the pump was on with no water. A hot tub is not like a water heater. It is only heating flowing water and not standing water.