How do you use reverb on snare?
Send the snare first to a short reverb. Start with a stereo ambience or nonlinear preset and set the reverb time between 200 and 500 milliseconds. Send a lot of snare to this reverb and listen to what it sounds like. Then turn down the reverb until you barely notice it.
Can you put reverb on drums?
When you’re adding reverb to drums, just like with vocals, guitars, and virtually any mix element, you’ll find there are a lot of advantages to applying it through an aux send, rather than just inserting the plugin directly on an individual track. You could also use the reverb’s output control for the same result.
Do you put reverb on kick drum?
As a general rule of thumb, I keep the kick drum pretty dry. Especially on rhythmic dance tracks. However, there is definitely a time and place to putting reverb on a kick. First off, there’s no rule against filtering the lows out of the reverb and just using it to add a bit of flavor to the top end of the kick.
Should snares have reverb?
Adding reverb to a raw snare track is a recipe for disaster. It’s likely that the raw track needs some TLC before a reverb makes sense. Things like cymbal bleed and low-end rumble might have built up in the mic. There might be a harsh or unnatural frequency that needs to be EQ’d out before you can proceed.
How loud should a snare mix be?
The snare is the foundation of the backbeat, and typically one of the loudest elements in the mix. Next, bring the kick fader up until it sounds almost as loud as the snare. It should be loud enough that the low frequencies are rich and powerful, but not so loud that it masks the bottom-end of the snare drum.
Why do my hi-hats sound bad?
If you push too hard on your hi-hat foot pedal, you will choke the cymbals, and this is a sure way to make even the best cymbals sound average. If there is too much separation between the two, you only get the high-pitched and somewhat piercing sound of the top cymbal.
Can you use reverb on drums in a mix?
When you’re adding reverb to drums, just like with vocals, guitars, and virtually any mix element, you’ll find there are a lot of advantages to applying it through an aux send, rather than just inserting the plugin directly on an individual track.
Which is the best wave plugin for snare drum?
Since this session includes two mics at the top of the snare drum and one snare bottom mic, the first step should be checking the phase relationship. InPhase by Waves lets you monitor two waveforms and make adjustments to correct for phase problems.
What kind of reverb do you use on waves?
For example, Waves H-Reverb (a hybrid reverb that combines elements of convolution and algorithmic reverb), offers many different reverb types in its preset menu. It’s convenient to step through them and listen for how they impact your kit and your song.
Why are the drums not reverberant in waves?
Because there was no room mic and the space it was recorded in wasn’t reverberant, the dry drums that you hear in the first two measures sound pretty flat and lifeless. Waves H-Reverb enters on measure 3 making it sound like it was recorded in a bigger live room.