How do you reset the filter on a Lux thermostat?

Posted on by Dominique Stacey

How do you reset the filter on a Lux thermostat?

If you wish to reset the FILTER Usage Monitor:

  1. Rotate the dial to “Air Filter”
  2. Press “Next”
  3. You will see the Filter Limit flashing.
  4. Press the Down button repeatedly to 30, 60, 90, 120, 180, or 360 days.
  5. If you wish to disable the filter reminder, just set it to “Off”.

How do you troubleshoot a LuxPro thermostat?

Luxpro Thermostat Not Working

  1. 1) Restart the Thermostat. One of the most common troubleshooting techniques that can help you out from most of the tight corners is restarting the thermostat.
  2. 2) Reset.
  3. 3) Clean it off.
  4. 4) Check the wiring.

How do I set the temperature on my LuxPro?

To adjust a LuxPro thermostat, use the thermostat buttons. To increase the air conditioning temperature, press the top or right button. To decrease the air conditioning temperature, press the bottom or left button.

How do I get my Lux thermostat to work?

Thermostat must be in either heat or cool position. SET Slide switch must be in the RUN position. Press the HOLD key to turn HOLD on and then again to turn it off. HOLD is only active when the word “HOLD” is visible in the display.

How do you unlock a pure pro thermostat?

Place the Set Slide switch in the RUN position. On the back of the thermostat’s circuit board, press and hold the “HW RST” (Hardware Reset) button for 3 seconds and release. The thermostat will perform a reset and should now be unlocked.

Why does my thermostat say check filter?

When you see the word “Filter” flashing in the display of the thermostat, it is simply a reminder to change the filter in the blower of your heating\cooling system (totally separate from thermostat). This feature does not affect the operation of thermostat in any way.

How do you unlock a luxpro thermostat?

To do that, follow these instructions:

  1. Bring the Set Slide switch to the RUN position.
  2. Behind the thermostat’s circuit board, you’ll find the HW RST button. This is used to perform a hard reset.
  3. Press and hold it for 3 seconds. This should unlock your thermostat.

What is the hold button for on a thermostat?

This is where the “Hold” button on your thermostat comes into play. By pressing “Hold”, your thermostat will lock in the temperature it’s currently at until you change it again. When you are ready for your normal schedule to resume, simply press the “Run” button and return to your typical programming.