How do I setup my Netgear router without the CD?

Posted on by Dominique Stacey

How do I setup my Netgear router without the CD?

  1. Connect the wireless router to your modem with an Ethernet cable plugged in to the “Internet” or “Line In” port.
  2. Open your browser and navigate to the following IP: http://www.routerlogin.net.
  3. Click the “Wireless Settings” link from your router’s dashboard to change settings.

How do I setup my Netgear n150 router?

  1. To connect the wireless router, the computer, and the modem:
  2. Turn off your computer.
  3. Turn off and unplug the cable or DSL broadband modem.
  4. Locate the cable (A) that connects your computer to the modem.
  5. Disconnect the cable at the modem end only (B). You will connect it to the router later.

Can you install a router without the CD?

In case your computer has no CD drive or you lost the Setup CD, you can still install your Linksys Wi-Fi Router by downloading the Linksys Connect Setup Software from the Linksys Support Site. To do this, you need to connect your computer first to a network with an active Internet connection or directly to the modem.

How do I configure my Netgear router?

How do I configure my NETGEAR router for cable Internet connection using Smart Wizard?

  1. Launch a web browser from a computer or mobile device that is connected to your router’s network.
  2. Enter your user name and password.
  3. In the upper-left corner of the screen, click Setup Wizard.
  4. Select Yes.
  5. Click Next.
  6. Click Next.

How do I download Netgear without WIFI?

Re: How to download drivers for netgear A210 without an internet connection.

  1. Go to second computer.
  2. Connect to internet.
  3. Download software.
  4. Copy to USB drive.
  5. Move USB drive to where you want the software.
  6. Copy software to that PC.

How do I turn my Netgear router into an access point?

How do I change my NETGEAR router to AP mode after setting it up?

  1. Enter your user name and password. Note: The default user name is admin. The default password is password.
  2. Select the ADVANCED tab.
  3. Click Advanced Setup > Wireless Settings.
  4. Scroll down to the AP Mode section and select Enable AP Mode.

How do I install firmware on my router?

How to update router firmware

  1. Connect the router to your computer with an Ethernet cable.
  2. Download the firmware update from the router manufacturer’s website.
  3. Log in to your router’s web management page.
  4. On that page, select the downloaded firmware to update your router.
  5. Reboot your router to finish the upgrade.

How do I configure Netgear?

How can I install TP link router without CD?

Setting Up Your TP-Link Router Without A CD: Use an Ethernet cable to connect the LAN port of the router to the Ethernet port of your computer. Now, connect your modem’s ADSL cable to the WAN port of the router. Next, turn off and on your computer, router, and modem. Then, wait for all the devices to boot up.

How do I install a used Netgear router?

To install your NETGEAR router using the router web interface:

  1. Using an Ethernet cable, connect your modem to the yellow Internet port on the back of your NETGEAR router.
  2. Connect your computer to one of the Ethernet ports on your router.
  3. Press the Power button on the router.
  4. Open a web browser and enter routerlogin.net.