How do you make a WatchGuard Bovpn?
- Select VPN > Branch Office VPN.
- Below the Gateways list, click Add.
- In the Gateway Name text box, type a name to identify this gateway.
- (Fireware v12.
- In the Credential Method section, select Use Pre-Shared Key.
- (Fireware v12.
- Type the shared key.
- Below the Gateway Endpoint list, click Add.
What is WatchGuard Bovpn?
Branch Office Virtual Private Networking (BOVPN) is used to create a secure tunnel over an unsecure network, between two networks or between a WatchGuard Firebox and another device.
What is Bovpn virtual interface?
A BOVPN virtual interface defines a BOVPN tunnel that is treated in the configuration like an interface. The Firebox uses the routes table to determine whether to route a packet through the BOVPN virtual interface or through another interface. For configuration examples, see BOVPN Virtual Interface Examples.
How do I enable SSH on WatchGuard?
To add an SSH host to the Access Portal, from Fireware Web UI:
- Click Add and select Host Shell Access (SSH).
- In the Name text box, type a name for the SSH connection.
- In the Description text box, type a description of the SSH connection.
- To select a custom icon for the application, select Custom Icon > Choose File.
How do you reset WatchGuard?
Reset Steps by Device Model
- Power off the Firebox.
- Press and hold the Reset button on the back of the Firebox.
- While you continue to hold the Reset button, power on the Firebox.
- Continue to press the Reset button until the Attn indicator begins to flash.
- Release the Reset button.
- Wait for the reset process to complete.
How do I enable RDP on WatchGuard?
Add an RDP Host
- Click Add.
- From the Type drop-down list, select Host Desktop Access (RDP).
- In the Name text box, type a name for the RDP connection.
- In the Description text box, type a description of the RDP connection.
- To select a custom icon for the application, select Custom Icon > Choose File.
What port does WatchGuard System Manager use?
The WatchGuard policy controls access to the Firebox on these TCP ports: 4105, 4117, 4118. When you allow connections in the WatchGuard policy, you allow connections to each of these ports.
How do I reset my WatchGuard firewall?
How do I reset my WatchGuard ap200?
Insert a pin or paperclip into the Reset button hole. Press and hold the reset button for up to 10 seconds until all LEDs go off to indicate that the AP has rebooted.